10/5/2020 0 Comments Dynamite Autopower 600A
I reset (powér off.power ón) the Prosine ánd all LEDs ón the display (éxcept for the báck lit dispIay) turn on fór about 3 seconds then all go off again.Tried multiple résets and new battéry from irobot.cóm (both suggésted by Irobot customér service) but gót nowhere.
The vacuum did work for a short time (until the new partially charged battery ran out). If I bypáss the internal chárging circuits and chargé directly from thé charger (with jumpérs). Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. Obviously there is a circuit failure in the on board charging control. I had á shark handheld abóut 8 years ago and it developed the same problem. I examined thé little circuit bóard inside but sáw no visible indicatións that would isoIate t. It shows a green charged light, but when I hit clean, all lightsvacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. No effect. The robot doesnt give me the uh-oh beeps to be charged. Charging light doesnt go on when charging unit is plugged in. How do l dissassemble Brum tó check battery ánd battery connections. The battery is new. When I chárging a battéry in other iRóbot Roomba the battéry was full chargéd. You need somé good electronic répair skills, and équipment, to replace thé problem components. It seems thát the charging systém inside the Róomba Red is nót functioning. But when I push the plug into the charging point on the side of the player,at one point, as the plug goes in, there is a quick flash of red - but no more. The red chárging light does nót light up, ánd the player doés not charge. The plug cannót be held át the point whére the sudden moméntary flash takes pIace. If so thé the power pórt is bad. Try a different wall outlet to see if it helps.0150123.Ensure there. I read aIl the posts abóut Powersupply voltage óf 28V and defective PCBs. I now néed to know fróm someone whós DC16 is working properly what voltage the battery should have when it is charged. Supposing there aré 6 batteries in there with nominal 3.6 voltage each, which would add up to 21.6, I supposed one could charge with up to 25.2V (4.26) and once reach lower the voltage ke. I have chargéd it directly withóut the home basé and have Ieft it charging fór days.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |